Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Calling up settings
- Selecting settings
- Changing a setting
- Closing the Settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Unit
- Brightness
- Display switch-off
- Program info
- Memory
- Soak duration
- Gentle action
- Temp. reduction
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-Crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- _
- Detergents and care products
Frequently Asked Questions
General problems with the washer
Problem Possible cause and solution
The washing machine is
emitting an odor.
The Sanitize info was not observed. When washing, a
wash program using a temperature above 60°C
(140°F) has not been run for a long time.
Run the Clean Machine program using a universal
powder detergent.
The washing machine is cleaned which prevents
bacteria and odor buildup.
The door and detergent dispenser drawer were
closed after washing.
Leave the door and the detergent dispenser
drawer slightly open to allow them to dry.
The washer shakes dur-
ing the spin cycle.
The four feet are not resting evenly on the floor.
Level the machine (see “Leveling the washer”).
The laundry has not
been spun properly and
the laundry is still wet.
The machine detected an imbalance during the final
spin and reduced the spin speed automatically.
Wash large and small items together in order to
achieve a more even load distribution.
There are unusual
sounds coming from
the drain pump.
There is no fault!
Lapping sounds at the beginning and end of the
drain process are normal.
The display shows a
foreign language.
The display language was adjusted.
Select the display language. See “Setting the
display language”.
71