Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Calling up settings
- Selecting settings
- Changing a setting
- Closing the Settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Unit
- Brightness
- Display switch-off
- Program info
- Memory
- Soak duration
- Gentle action
- Temp. reduction
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-Crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- _
- Detergents and care products
Frequently Asked Questions
Fault message after the end of the program
Problem Possible cause and solution
Align the washing
machine
The SoftSteam extra option which runs at the end of
the program could not be carried out properly.
Check whether the washing machine is aligned
correctly (see “Installation – Leveling the
machine”).
Check whether the maximum drain height of 3'
3" (1m) has been exceeded.
If the fault message appears again, contact Miele
Customer Service. The washing machine can still be
used, but without the SoftSteam extra option.
Check filter + jets
The pumps are dirty.
Clean the pumps as described in “Frequently
asked questions – Opening the door in the event
of a blocked drain and/or power failure”.
Start a wash program again after cleaning.
The jet in the top of the door ring is blocked with lint.
Remove the lint with your finger. Do not use any
sharp or pointed tools to do this.
Start a wash program again after cleaning.
If the fault message appears again, contact Miele
Service. The washing machine can still be used but
with reduced functionality.
The messages will appear at the end of the program and when the washing
machine is switched on, and need to be confirmed with the OKsensor button.
68