Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Calling up settings
- Selecting settings
- Changing a setting
- Closing the Settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Unit
- Brightness
- Display switch-off
- Program info
- Memory
- Soak duration
- Gentle action
- Temp. reduction
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-Crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- _
- Detergents and care products
Frequently Asked Questions
Fault message after the end of the program
Problem Possible cause and solution
Check dosage
Excessive foam has built up during washing.
With TwinDos, check the dosage amount set.
Reduce the amount set in 10% increments.
Use less detergent next time and follow the
manufacturer’s instructions on dosage given on
the packaging.
Sanitize info: Run a
high temp. program
or the “Clean Ma-
chine” program
When washing, a wash program using a temperature
above 140°F (60°C) has not been run for a long time.
Turn the program selector toAdditional programs/
.
Touch the sensor buttons until Maintenance
appears in the display.
Touch the OKsensor button.
The following appears in the display: Clean Machine
Touch the OKsensor button.
Run the Clean Machine program using a universal
powder detergent.
The washing machine is cleaned which prevents
bacteria and odor buildup.
The messages will appear at the end of the program and when the washing
machine is switched on, and need to be confirmed with the OKsensor button.
67