Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Calling up settings
- Selecting settings
- Changing a setting
- Closing the Settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Unit
- Brightness
- Display switch-off
- Program info
- Memory
- Soak duration
- Gentle action
- Temp. reduction
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-Crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- _
- Detergents and care products
5. Adding detergent
37
Close the lid and press it firmly shut.
Close the detergent dispenser
drawer.
The capsule is opened by the act of
inserting it in the detergent dispenser
drawer. The contents can run out of
the capsule if you then remove it
from the drawer before it is used.
Dispose of opened capsules.
The contents of the capsule will be
added to the wash program at the
correct time.
During CapDosing, water intake to
the compartment takes place
solely via the capsule.
Do not add any additional fabric
softener to the compartment.
Remove the empty capsule at the
end of the wash program.
For technical reasons, a small amount
of water will remain in the capsule.
Deactivating or changing
CapDosing
CapDosing can only be deactivated or
changed prior to program start.
Touch the sensor button.
Select No Cap (deactivate) or a
different type of capsule (change).
Color run and dye removers
Damage due to color run/dye
removers.
Color run and dye removers can
cause corrosion in the washing
machine.
Do not use color run or dye removers
in the washing machine.
Dyes suitable for use in domestic
washing machines can be used.
However, please note that the salt used
in the dyeing process can cause
corrosion to stainless steel components
in the machine if you use dye
frequently. Always observe the dye
manufacturer’s instructions carefully.