Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Calling up settings
- Selecting settings
- Changing a setting
- Closing the Settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Unit
- Brightness
- Display switch-off
- Program info
- Memory
- Soak duration
- Gentle action
- Temp. reduction
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-Crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- _
- Detergents and care products
4. Selecting program settings
29
Delay start/SmartStart
Delay Start
With the Delay Start function, you can
delay the start of the program.
This function is active when the
setting SmartGrid is switched off.
The hours can be set in the values from
00 to 24. The minutes can be set in 15-
minute increments from 00 to 45.
Setting the Delay Start time
Touch the sensor button.
The following will appear in the display:
Start in
OK
Std:0000
Set the hours with the sensor
buttons. Confirm with the OK sensor
button.
The display will change:
Start in
OK
Std0006:
Set the minutes with the sensor
buttons. Confirm with the OK sensor
button.
Tip: The values will count upward and
downward automatically if you keep
your finger on the sensor buttons.
Canceling Delay Start
The selected delay-start period can be
canceled before the program starts.
Touch the sensor button.
The selected delay-start period will
appear in the display.
Set a time value of 00:00 h with the
sensor buttons. Confirm with
the OK sensor button.
The selected delay-start period has
been canceled.
After the program has started, the
selected delay-start period can only
be changed or canceled by
interrupting the program.
Changing Delay Start
The selected delay-start period can be
changed before the program starts.
Touch the sensor button.
Change the specified time and
confirm with the OK sensor button.