Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Calling up settings
- Selecting settings
- Changing a setting
- Closing the Settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Unit
- Brightness
- Display switch-off
- Program info
- Memory
- Soak duration
- Gentle action
- Temp. reduction
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-Crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- _
- Detergents and care products
Before using for the first time
20
Push the UltraPhase1 detergent
cartridge into compartment1 until it
locks into position.
Settings for compartment
The UltraPhase2 values are pre-set in
the standard default settings.
After the cartridge has been pushed in,
the display message switches to:
Agent for
OK
Confirm with the OKsensor button.
Miele UltraPhase 2
OK
Confirm with the OKsensor button.
The dispensing quantity for
UltraPhase2 for (hardness level I)
is pre-set.
Per load
OK
ml36
Confirm the pre-set value with the
OKsensor button. If you want to
change this value, use the
sensor buttons and confirm with
the OKsensor button.
UltraPhase2
Hardness level I 36ml
Hardness level II 45ml
Hardness level III 54ml
The following will appear in the display:
Insert
Remove the cover from the detergent
cartridge.