Operating instructions/Installation instructions

Settings
94
Display switch-off
The display and the sensor button
lighting is switched off to save energy.
The Start/Add laundrysensor button
flashes slowly.
Options
- On(factory default)
The lighting switches off after
10minutes.
- On (not crnt prog)
The lighting remains switched on
throughout the program. The lighting
switches off 10minutes after the
program has ended.
- Off
The lighting remains switched on.
Program info
You can select the information that will
be displayed temporarily once a
program has been selected in the
display.
Options
- Program name
The program name is shown in the
display for several seconds.
- Prog. & Max load (factory default)
The program name and the maximum
load are shown in the display for
several seconds.
- Off
Directly after the program has been
selected, the standard display is
shown with temperature, spin speed,
and program duration.
Memory
The washing machine will save the
last settings (temperature, spin speed,
and some of the extra options)
selected for a wash program after the
program has started.
When the program is chosen again, the
saved settings will appear on the
display.
Memory is deactivated as standard.
Water intake
You can program 2 options for the
water inlet. The water inlet is
controlled by the two inlet hoses.
Options
- Cold water
The washing machine will be
operated with cold water only.
- Hot water  (default setting)
Hot water is used in the main wash to
save energy.
You can heat up your water with
cheaper, primary energy sources,
e.g., gas, solar power, oil. The
temperature must be below 140°F
(60°C.)
 For technical reasons, the
washing machine must always be
connected to cold water.