Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Adding detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- Fault message after a program has been interrupted
- Fault message after the end of the program
- Messages or faults affecting the TwinDos system
- Messages or faults affecting the TwinDos system
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Settings
- Calling up settings
- Selecting settings
- Changing a setting
- Closing the Settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Code
- Unit
- Brightness
- Display switch-off
- Program info
- Memory
- _
- Soak duration
- Gentle action
- Temp. reduction
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-Crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- _
- Copyrights and licenses for the communication module
- Detergents and care products
Changing the program sequence
54
Changing a program (safety
lock)
A program, temperature, spin speed, or
selected extra options cannot be
changed once the machine has been
successfully started. This prevents the
machine being operated unintentionally,
e.g., by children.
If the washing machine is switched off
during active program operation, the
standby function does not switch the
washing machine off completely after
15minutes. Safety functions continue
to be active because there may still be
water inside the drum.
Interrupting a program
Turn the program selector to the
position.
To continue, turn the program
selector to the position of the wash
program that was started.
Cancel?
OK
Yes
Touch the sensor button.
The following will appear in the display:
Cancel?
OK
No
Confirm with the OKsensor button.
Tip: If Change not possible appears in
the display, the program selector is in
the incorrect position.
Canceling a program
You can cancel a wash program at any
time after it has started.
Turn the program selector to the
position.
Turn the program selector to the
Normal program.
The following will appear in the display:
Cancel?
OK
Yes
Touch the OKsensor button.
The suds are pumped away. The
following will appear in the display:
Program Canceled
OK
Wait until the symbol in the display
goes out and the door unlocks.
Pull open the door.
Remove the laundry.