User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Problem solving guide
88
Fault messages at the end of a programme
Message Possible cause and remedy
Align the machine.
Laundry not properly
spun.
The smoothing process which the laundry undergoes
at the end of the programme could not be carried out
properly.
Check whether the washer-dryer is aligned
correctly as described in “Installation – Levelling
the machine”.
Check whether the maximum delivery head of
1.0m has been exceeded.
If the fault message appears again, contact Miele.
The washer-dryer can still be used but with reduced
functionality.
Hygiene info: Select
"Maintenance" and
start the "Clean
machine"
programme.
No drying programme or no wash programme using
a temperature above 60°C has been run for a long
time.
In order to prevent bacteria and unpleasant odours
building up in the machine, run the Clean machine
programme using the Miele machine cleaner or
powder detergent.
To switch off the fault message, switch the washer-dryer off with the sensor.