User Manual

Problem solving guide
86
Fault messages after a programme has been cancelled
Problem Possible cause and remedy
 Water intake fault.
Turn on the tap.
The water inlet is blocked or restricted.
 Check whether the tap is turned on properly.
 Check whether the inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
 Drainage fault. Clean
drain filter and pump.
Check the drain
hose.
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 Check whether the maximum delivery height of
1m has been exceeded.
 Waterproof system
activated. Turn off
the tap. Call Miele.
The water protection system has reacted.
 Turn off the tap.
 Call Miele.
 Fault F. If restart
fails, call Miele.
There is a fault.
 Disconnect the washer-dryer from the electricity
supply. Switch off at the wall and withdraw the
plug from the socket, or switch off the mains
circuit breaker.
 Wait at least 2minutes before reconnecting the
washer-dryer to the electricity supply.
 Switch the washer-dryer back on.
 Restart the programme.
 If the fault message appears again, contact Miele.
To switch off the fault message, switch the washer-dryer off with the  sensor.