User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Timer/SmartStart
78
Timer
The Timer can be used to set the time
at which a programme starts or finishes.
The programme start can be delayed by
up to 24hours.
Setting the Timer
Touch the Timersensor.
Select the Finish at or Start at option.
Set the hours and the minutes and
confirm your entry with the OK
sensor.
Altering the Timer
The selected timer can be changed
before the programme starts.
Touch the or sensor.
Change the time set and confirm with
the OK sensor.
Deleting the Timer
The selected timer can be deleted
before the programme starts.
Touch the or sensor.
The selected time for the timer appears
in the display.
Touch the Deletesensor.
Confirm with the OK sensor.
The selected time for the timer is now
deleted.
Starting the Timer
Touch the Start/Stop sensor.
The door will lock and the time
remaining until the programme starts
will appear in the display.
After the programme has started, the
selected time for the timer can only be
changed or cancelled by interrupting
the programme.
The programme can be started
immediately at any time.
Touch the Start immediatelysensor.