User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Changing the programme sequence
75
Changing the programme
(safety lock)
It is not possible to change the
programme, the temperature, the spin
speed or the selected Extras after the
programme has started. This prevents
the appliance being operated
unintentionally, e.g. by children.
If the washer-dryer is switched off
during active programme operation,
the standby function does not switch
the washer-dryer off completely after
15minutes. Safety functions continue
to be active because there may still be
water inside the drum.
Cancelling a programme
You can cancel a programme at any
time after it has started.
Touch the Start/Stopsensor.
The following will appear in the display:
Cancel the programme?
Select Yes.
- During washing
The suds will be pumped away and the
programme is cancelled.
- During drying
The laundry will be cooled down before
the door can be opened.
Removing the laundry
Wait until the symbol in the display
goes out and the door is unlocked.
Pull the door open and unload the
drum.
Selecting another programme
Close the door.
Select the required programme.
Add detergent to the detergent
dispenser drawer, if necessary.
Touch the Start/Stop sensor.
The programme will start.
Interrupting a programme
Switch the washer-dryer off with the
sensor.
To continue the programme, switch
the washer-dryer back on with the
sensor.
Danger of overheating due to hot
laundry.
Hot laundry can ignite.
Never switch the washer-dryer off
during a drying programme.
If you absolutely must interrupt the
programme, remove all items
immediately and spread them out to
cool down.