User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Drying
62
3. Selecting programme
settings
Selecting a thermospin spin speed
The preset spin speed for the
thermospin can be changed if
required.
Touch the Spin speedsensor.
Select the desired spin speed.
The display will change to the standard
menu for that drying programme.
Selecting the drying level
The preset drying level for a
programme can be changed if
required.
Touch the Drying levelsensor.
Select the desired drying level.
The display will then change to the
standard menu for the programme.
Selecting Extras
You can supplement programmes with
Extras.
Touch the Extras sensor.
Select one or more Extras.
Not all Extras can be combined.
Extras that cannot be combined are
greyed out and cannot be selected.
Confirm with the OK sensor.
The display will then change to the
standard menu for the programme.
See “Drying – Extras” for more
information.
Timer
You can use the Timer to set the finish
time or the start time for a programme.
See “Timer/SmartStart” for further
information.