User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Washing
52
= low water level
= medium water level
= high water level
= intensive rhythm
= normal rhythm
= sensitive rhythm
= ultra sensitive rhythm
= handwash rhythm
= carried out
– = not carried out
This washer-dryer has fully electronic
controls with automatic load
recognition. It takes in the right amount
of water required for the programme
depending on the amount of laundry
and its absorbency rate.
The programme sequences outlined are
based on the standard programme with
a full load.
The washer-dryer's display continually
shows which stage of the programme
has been reached.
Special features in the programme
sequence
Anti-crease
At the end of the programme, the drum
continues to turn at intervals for up to
30 minutes to help prevent creasing.
Exception: There is no Anti-crease
phase in the Woollens and Silks
programme.
The drum door can be opened at any
time during the anti-crease phase.
1
If a temperature of 60°C or higher is
selected, 2 rinses are carried out. If a
temperature of less than 60°C is
selected, 3 rinses are carried out.
2
An additional rinse is carried out if:
- there is too much foam in the drum
- the final spin speed is less than
700rpm
3
An additional rinse is carried out if:
- the Extra rinse Extra has been
selected
4
Pre-wash:
- A pre-wash is carried out
automatically to remove dust.
5
Run-up to spin:
- A run-up to spin is carried out before
the wash process begins to deflate
down-filled items. Subsequent water
intake for the main wash is through
compartment II.