User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Washing
44
Final spin speed in wash
programmes
When a programme is selected, the
optimum spin speed for this wash
programme is shown in the display.
A faster spin speed can be selected for
certain wash programmes.
The highest selectable spin speed is
indicated in the table.
Omitting the final spin (Rinse hold)
Select the Rinse hold Extra.
The laundry is not spun after the final
rinse and remains in the rinse water.
This helps prevent creasing if the
laundry is not going to be removed from
the drum immediately after the end of
the programme.
To start the final spin:
The wash programme is set to the
optimum spin speed. You can change
the spin speed.
Touch the Change spin speedsensor.
Select the desired spin speed.
Start the final spin with the Start/Stop
sensor.
Ending the programme:
Touch the Change spin speedsensor.
Select the spin speed 0 rpm (no
spin).
Touch the Start/Stop sensor.
The water will be pumped away.
Interim spin
There is a spin cycle after the main
wash and between the rinses. A
reduction in the final spin speed will
also reduce the interim spin speed as
appropriate.
Deselecting the interim spin and the
final spin
Touch the Spin speedsensor.
Select the spin speed 0 rpm (no
spin).
After the last rinse cycle, the water will
be pumped away and the Anti-crease
phase will switch on.
In some programmes an additional rinse
is introduced with this setting.