User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Washing
34
Selecting Extras
You can supplement the wash
programmes with Extras.
Touch the Extras sensor.
Select one or more Extras.
Not all Extras can be combined.
Extras that cannot be combined are
greyed out and cannot be selected.
Confirm with the OK sensor.
The display will change to the standard
menu for that wash programme.
See “Washing – Extras” for more
information.
Activating CapDosing
You can use CapDosing with a wash
programme.
Touch the CapDosing sensor.
The types of capsules which can be
used with the programme will appear in
the display.
Select the type of capsule you want
to use.
CapDosing is now active.
The display will then change to the
standard menu for that wash
programme.
See “Washing – 5.Adding detergent -
CapDosing“.
Selecting stains
In order to clean stained laundry more
effectively, you can choose from a list
of various types of stains. The wash
programme will then adapt to the type
of stain selected.
Touch the Stainssensor.
Select the type of stains in your load
from the list.
Confirm your selection with the OK
sensor.
With some stains, helpful information
will also appear in the display when
they are selected.
Confirm the information with the
OKsensor.
The display will then change to the
standard menu.
Timer
You can use the Timer to set the finish
time or the start time for a programme.
See “Timer/SmartStart” for further
information.