User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Before the first use
29
6. Starting the calibration
programme
It is important to calibrate the washer-
dryer to ensure optimum water and
energy usage, as well as optimum
washing and drying results.
To do this, the Cottons programme
must be run without laundry and
without detergent.
No other programmes can be started
until calibration has been carried out.
The following message appears in the
display:
Turn on the tap and run the Cottons 90°C
programme without any laundry
Confirm with the OK sensor.
The display will then change to the
standard display for the Cottons
programme.
11:02
90 °C 1600
1:57
Cottons
h
Washing
Temperature Spin speed
TwinDos Extras
not selectedWhites
Timer Save
rpm
Turn on the tap.
Touch the Start/Stop sensor.
The calibration programme will start. It
will take approximately 2hours.
At the end of the programme the
following message will appear in the
display:
Set-up completed
Reach under the door grip and pull
the door open.
Useful tip: For safety reasons, close the
door when the machine is not in use.
Otherwise there is a danger of objects
being placed inadvertently in the drum.
If these remain unnoticed and were
washed in the next load, they could
damage the laundry. An open door is
also a danger to pets and children.
Switch the washer-dryer off with the
sensor.