User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Before the first use
26
5. Setting up TwinDos
Skip
Continue
Set up "TwinDos"?
Touch the Continue sensor to set up
TwinDos straight away.
Useful tip: To postpone set-up until
later: touch the Skip sensor. The
following message will then appear in
the display:
It is possible to set up later in "Settings" /
"TwinDos".
Confirm with the OK sensor.
Setting up compartment
The procedure below describes the
procedure for Miele UltraPhase1 and
Miele UltraPhase2. The procedure for
other detergents is similar.
No agent
Agent for comp.
Miele
UltraPhase 1
Universal
detergent
Colour
detergent
Delicates
detergent
Delicates/
Woollens
OK
11:02
Touch the Miele UltraPhase 1sensor.
The following message appears in the
display:
Please enter the dosing recommendation
of your detergent for a wash with normal
soiling. Take note of your water hardness
level.
The dispensing quantity for
UltraPhase1 is preset for (water
hardness level I).
46
44
56
47
48
Dosage for comp.
ml
OK
11:02
Confirm the preset value with the OK
sensor, or change the value.
UltraPhase1
Hardness level I 46 ml
Hardness level II 58 ml
Hardness level III 70 ml
The following will appear in the display:
Insert container