User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Before the first use
25
3. Setting the clock format
The time of day display can be in 12h
or 24h clock format.
Select the clock format you want and
confirm this with the OK sensor.
The display will then bring up the
screen for setting the time of day.
Setting the time of day
This message only appears if the
washer-dryer has not yet been
connected to a Wi-Fi network. The
time of day is set automatically if
connection is established with a Wi-Fi
network.
12 00
11 59
10 58
13 01
14 02
Time
OK
Place your finger on the number that
you want to change and move your
finger in the desired direction.
Confirm with the OK sensor.
4. Removing the transit bars
Damage resulting from failure to
remove the transit bars.
Failure to remove the transit bars can
result in damage to the washer-dryer
and to adjacent cabinetry or
appliances.
Remove the transit bars as described
in “Installation”.
The following message appears in the
display:
Remove transit bars and observe
"Warning and Safety instructions" and
"Before using for the first time" in the
operating instructions
Confirm that the transit bars have
been removed with the OKsensor.
The display will change to the next
setting.