User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Operating the washer-dryer
20
Extras menu (multiple selection)
11:02
Quick
Soak
Water plus
Extra rinse
Extras
OK
You can scroll to the right or the left by
swiping your finger across the screen.
Place your finger on the touch display
and swipe it in the direction you want.
The orange bar under the pictures
shows that there are further options to
choose from.
To select Extras, touch one or more
sensors with Extras.
Currently selected Extras are marked
orange.
To deselect an Extra, simply touch the
Extrasensor again.
Use the OK sensor to activate the
selected Extras.
Setting numerical values
You can set numerical values in some
menus.
12 00
11 59
10 58
13 01
14 02
Time
OK
Enter the numbers by swiping upwards
or downwards. Place your finger on the
number that you want to change and
move your finger in the desired
direction. Use the OK sensor to accept
the set numerical value.
Useful tip: Briefly touching the
numbers will bring up the numerical
keypad. Once a valid number has been
entered, the OK sensor will be
highlighted green.