User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Operating the washer-dryer
17
Control panel
a
sensor
Takes you back one level in the menu.
b
Touch display
c
Start/Stop sensor
Touching the Start/Stop sensor starts the selected programme or cancels a
programme that has already started. The programme can be started as soon as
the sensor is flashing on and off. The sensor lights up constantly once the
programme has started.
d
Optical interface
For service technicians.
e
sensor
For switching the washer-dryer on and off. The washer-dryer switches off
automatically to save energy. It is switched off 15minutes after the end of the
programme/Anti-crease phase, or after being switched on if no further selection
is made.
Touch display and sensors
The and Start/Stop sensors and the sensors in the display react to fingertip
contact.
The touch display can be scratched by pointed or sharp objects, e.g. pens.
Only touch the display with your fingers.