User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Settings
113
Default settings can be altered to
adapt the washer-dryer to different
requirements. Settings can be altered
at any time.
Calling up settings
Switch the washer-dryer on.
Scroll through the main menu until
Settings appears.
Touch the Settingssensor.
The display will change to show the
Settings menu.
Selecting settings
The settings are grouped into different
areas.
11:02
Controls /
Display
Settings
Network
Programme
sequence
Appliance
parameters
Installation
requirements
Select the required area.
Scroll through the list until the setting
you want appears.
Touch the sensor to select the setting
you require.
Changing a setting
Change the value displayed and
confirm with OK...
...or touch an option to select it.
An option which is selected will be
highlighted orange.
The option is saved. The display will
then switch to the Settings menu, or go
back to the previous menu level.
Closing the Settings menu
Touch the sensor.
The display will go back to the previous
menu level.
Touch the sensor.
The display will change to the main
menu.