User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Installation
*INSTALLATION*
106
The Miele water protection
system
The water protection system protects all
parts of the washer-dryer from water
damage.
The system consists of three main
components:
- the inlet hose
- the electronic unit, and the drainage
and overflow protection
- the drain hose
Inlet hose
- Protects the safety valve from
bursting
The inlet hose can withstand
pressure of more than 14,000kPa.
- Protective sleeve
The inlet hose has a protective sleeve
which is made from metal braiding as
a “second skin” to protect the hose
against damage.
Electronic unit and machine housing
- Sump
Any leaking water is collected in a
sump in the base of the machine. A
float switches off the water inlet
valves. Further water intake is
blocked. The water inside the suds
container is pumped out.
- Overflow protection
This prevents the machine from
taking in too much water and
overflowing. If the water level
exceeds a certain level, the drain
pump switches on and pumps the
excess water away.
Drain hose
The drain hose is protected by a
ventilation system which prevents the
machine from being emptied
completely.