User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before the first use
- _
- Removing the protective foil and advertising stickers
- Remove the detergent cartridges and the drain hose elbow from the drum
- Miele@home
- Switching the washer-dryer on
- 1. Setting the language
- 2. Setting up Miele@home
- 3. Setting the clock format
- 4. Removing the transit bars
- 5. Setting up TwinDos
- 6. Starting the calibration programme
- Environmentally friendly washing and drying
- Washing
- 1. Preparing the laundry
- 2. Selecting a programme
- 3. Selecting programme settings
- 4. Loading the drum
- 5. Adding detergent
- TwinDos
- Detergent dispenser drawer
- CapDosing
- 6. Starting the programme
- Saving energy
- Adding laundry - AddLoad
- 7. End of the programme/unloading laundry
- Spin cycle
- Programme chart
- Programme sequence
- Extras
- Detergent
- Drying
- Washing and Drying
- After each washing or drying programme
- Changing the programme sequence
- Favourite programmes
- Washing/Drying assistant
- Timer/SmartStart
- Cleaning and care
- Problem solving guide
- A programme cannot be started
- Fault messages after a programme has been cancelled
- Fault messages at the end of a programme
- Fault messages at the end of a programme
- Problems with TwinDos
- Problems with TwinDos
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Garment care label symbols
- Settings
- Detergents and care products
Installation
*INSTALLATION*
105
Levelling the washer-dryer
The washer-dryer must stand perfectly
level on all four feet to ensure safe and
proper operation.
Incorrect installation may increase
electricity and water consumption and
may cause the machine to move about.
The appliance must not be
installed behind a lockable door, a
sliding door or a door with a hinge on
the opposite side to that of the
appliance, in such a way that a full
opening of the appliance door is
restricted.
Screwing out and adjusting the feet
The 4 adjustable feet are used to level
the washer-dryer. All four feet are
screwed in when the appliance is
delivered.
Using the spanner supplied, turn
counter nut 2 in a clockwise direction.
Then turn counter nut 2 together with
foot 1 to unscrew.
Use a spirit level to check the
washer-dryer is standing level.
Hold foot 1 securely with a pipe
wrench. Turn counter nut 2 again
using the spanner supplied until it sits
firmly up against the housing.
Risk of damage from incorrectly
aligned washer-dryer.
There is a danger of the washer-
dryer moving about if the feet are not
secured.
Turn all 4 counter nuts for the feet
until they sit firmly up against the
casing. Please also check this for the
feet which did not need adjustment.