User Manual

Installation
*INSTALLATION*
102
Installation surface
A concrete floor is the most suitable
installation surface. It is far less prone
to vibration during the spin cycle than
wooden floorboards or a carpeted
surface.
Please note:
 The washer-dryer must be level and
securely positioned.
 To avoid vibrations during spinning
the washer-dryer must not be
installed on soft floor coverings.
If installing on a wooden joist floor,
please note:
 Check for the presence of pipes and
cables first.
 Use a plywood base underneath the
washer-dryer (at least
59x52x3cm). The base must span
several joists and be bolted to the
joists and not only to the floorboards.
Useful tip: If possible, install the
washer-dryer in a corner of the room, as
this is usually the most stable part of
the floor.
Carrying the washer-dryer to
its installation site
 Danger of injury due to
unsecured lid.
Make sure the fixings at the back of
the lid are secure. They may become
brittle due to external circumstances.
There is a danger of the lid being
pulled off when carrying the
appliance.
Before carrying the machine, check
that the lid is secure where it
protrudes at the back of the
machine.
 Carry the washer-dryer by the front
feet and by the lid where it protrudes
at the back of the appliance.
Removing the transit bars
Removing the left transit bar
 Push the flap outwards and turn the
transit bar 90° using the enclosed
spanner.