Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Loading the tumble dryer
- 3. Selecting a program and starting it
- 4. Removing the laundry at the end of the program
- Delay Start/SmartStart
- Program chart
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- Customer Service
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Programmable functions
Frequently Asked Questions
Problem Possible cause and solution
Lines flash and light up
after turning on: .
Program selection is
not possible.
Access via a PIN code has been activated.
See “Programmable functions”, “PIN code”.
and another
number combi-
nation flash after
a program has
been cancelled, a
signal sounds.
There is no obvious cause.
Switch the dryer off and then on again.
Start a program.
If the program is interrupted again and an error
message appears, there is a fault. Contact Miele
Service.
: lights up and the
program has been can-
celled, a signal sounds.
The laundry is unevenly distributed or has rolled up.
Untangle the laundry and remove a few items if
necessary.
Switch the dryer off and then on again.
Start a program.
lit and program start
is not possible.
An update is available for the tumble dryer. See
“Programmable functions – RemoteUpdate” for
more information.
52