Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Energy-saving tips
- Functioning of the heat-pump dryer
- Initial set-up
- 1. Notes on correct laundry care
- 2. Loading the tumble dryer
- 3. Selecting a program and starting it
- 4. Removing the laundry at the end of the program
- Delay Start/SmartStart
- Program chart
- Changing the program sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- Customer Service
- IMPORTANT SAFETY INSTRUCTIONS
- Installation
- Technical data
- Programmable functions
Cleaning and care
48
Cleaning the plinth filter
Pull the handle out of the plinth filter.
Clean the plinth filter thoroughly
under running water.
Squeeze the plinth filter very carefully
several times as you rinse it.
Rinse the plinth filter until all visible
residues have been removed.
Use a damp cloth to remove any lint
from the handle.
Damage caused by a damaged
or worn plinth filter.
The heat exchanger will clog up if the
plinth filter is not in good working
order. This can cause a fault.
Check the plinth filter following the
instructions provided in “Frequently
Asked Questions – Replacing the
plinth filter”. Replace the plinth filter if
necessary.
Install the plinth filter back on the
handle. Make sure it is the correct
way round.
Push the plinth filter in completely.
This will push in the right-hand guide
pin at the same time.