operating instructions

Frequently Asked Questions
54
With the help of the following guide minor faults in the performance of the
machine, some of which may result from incorrect operation, can be remedied
without contacting the Service Department. Time and money will be saved
because a service call will not be needed.
This guide may help you to find the reason for the fault, and how to correct it.
Some of the messages in the display are more than one line long. Touch the  or
 sensor button to read them in full.
The display indicates the following messages or faults
Message Possible cause and solution
000 lights up after
switching on.
Access via a PIN code has been activated.
 You can enter the code.
See "Settings – PIN Code".
End/Cooling down The laundry will be cooled down at the end of the
program.
 Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
 Clean the lint filter
and the plinth filter.
See  lights up
at the end of a
program.
There is a build-up of lint in the airways.
 Clean the lint filters.
 Clean the plinth filter.
See "Cleaning and care".
To switch off the message:
 Confirm with OK.
 Clean the lint filter
and the plinth filter.
See  lights up
after a program
has been
interrupted.
An excessive amount of lint has built up.
 Clean the lint filters.
 Clean the plinth filter.
 Clean the air duct area underneath the plinth filter.
 Clean the heat exchanger.
To switch off the message:
 Switch the dryer off and then on again.