Technical information

Technical Information
94
G 600/G 800
2. Press and hold the Top solo button while switching the appliance on at the on/off
switch. Release the Top solo button within 2 seconds.
3. The On LED lights up and the Softener LED flashes (if this is not the case,
repeat Steps 1 and 2).
4. Set the program selector switch to the desired function (see Table 6-20).
5. Press Top solo to toggle between the available options.
6. To save the option: Turn the program selector switch to Stop and switch the
appliance off.
Selector switch position Function Programmable options Top solo LED
1 o’clock Drying
Normal
1
Off
Drying Plus On
2 o’clock Water hardness - Off
2
3 o’clock
Temperature
reduction
None
1
Off
Reduction of 9°F On
Table 6-20: G 680, G 880 Programming Functions
1
Standard setting
2
Setting not possible; "without softener" is programmed. Modify in service mode 2 (see Section
6.8.4.3), then repeat Steps 1 and 2.
6.8.4.1.1 Setting the Water Hardness
1. Access programming mode.
2. Turn the program selector switch to the 2 o'clock position.
3. Press the Top solo button.
4. Turn the program selector switch to the desired water hardness setting (see Table 6-21).
5. To save the setting, press Top solo, turn the program selector switch to Stop and switch
the appliance off.
Appliance width [cm] Water hardness
Program selector
switch position
(o’clock)
Water hardness
selector in
cabinet
45 (Slimline models)
1 - 5 1 6
6 - 7 2 6
8 3 6
9 4 6
10 - 11 5 6
12 - 14 6 6
15 - 16 7 6
17 - 21 8 6
22 - 24 9 6
25 - 31 10 6
32 - 35 11 3
36 - 47 11 4
48 - 64 11 5
65 11 6