Technical information

Technical Information

G 600/G 800

6.8.3.3.2 Deleting Stored Fault Codes

Access Programming Mode and turn the dishwasher off.

6.8.3.3.3 Program Index

1. Access Service Mode 2.

2. Turn the program selector switch to the 2 o’clock position. The Top solo light flashes.

3. Press the Top solo button once, then turn the program selector switch slowly clockwise

until the Top solo light lights up. The program selector switch position will determine the

corresponding program index, as shown in Table 6-18 below.

4. Turn the dishwasher off.

Program selector position Program index Electronic version

1 o’clock P0 EPLG 542/544

2 o’clock P1 For future modifications

3 o’clock P3 For future modifications

Table 6-18: G 811, G 851, G 851 Plus, G 856, G 856 Plus Program Indices

6.8.4 G 680, G 880

Programming Flow Chart

Enter Programming Mode

To access:

Water hardness

Drying Plus (EPLZ 501 only)

Temperature reduction (EPLZ 501 only)

Enter Service Mode 1

To access:

Switching step check

Test program

Enter Service Mode 2

To access:

Fault indication

Program index

Temperature increase

Softener

Flow meter

Dishwasher width setting

Increased water quantity (EPLZ 520 only)

Table 6-19: G 680, G 880 Programming Flow Chart

Note:

Electronics EPLZ 501 and EPLZ 520 differ from each other in housing, plug

configuration and software. The designation can be checked in Service Mode 2.

EPLZ 520 is marked with the program index “P3” or higher.

6.8.4.1 Programming Mode

Switch the appliance off at the on/off switch, close the door and turn the program

selector switch to Stop.