Technical information

Technical Information
89
G 600/G 800
Selector switch position Fault code Fault
5 o’clock F04
Heating failure - heating circuit opened or
defective electrical component in heating circuit
6 o’clock F05 Water drainage failure, heater pressure switch
7 o’clock F06
Too few pulses at flow meter / start of water
intake
8 o’clock F07
Too few pulses at flow meter / end of water
intake
9 o’clock F08 Water intake failure, heater level switch
10 o’clock
F09
Heater level switch not switching on at the end
of thermal stops
Table 6-11: G 848 Fault Code Chart
6.8.2.3.2 Deleting Stored Fault Codes
Access Programming Mode and turn the dishwasher off.
6.8.2.3.3 Program Index
1. Access Service Mode 2.
2. Turn the program selector switch to the 2 o’clock position. The Start light flashes.
3. Press the Start button once, then turn the program selector switch slowly clockwise until
the Start light lights up. The program selector switch position will determine the
corresponding program index, as shown in Table 6-12 below.
4. Turn the dishwasher off.
Selector switch position Program index Electronic version
1 o’clock P0 EPLG 540
2 o’clock P1 For future modifications
3 o’clock P3 For future modifications
Table 6-12: G 848 Program Indices
6.8.3 G 811, G 851, G 851 Plus, G 856, G 856 Plus
(G 856 shown)
Programming Flow Chart
Enter Programming Mode
To access:
Water hardness settings
Extended drying 14 minutes
Extended water intake
Enter Service Mode 1
To access:
Manual step mode
Component test program