Technical information

Technical Information
86
G 600/G 800
6.8.2 G 848
Programming Flow Chart
Enter Programming Mode
To access:
Water hardness settings
Extended drying 4.5 - 14 minutes
Water intake time
Enter Service Mode 1
To access:
Manual step mode
Component test program
Enter Service Mode 2
To access:
Error messages
Program index
Increased water temperature selection
Water softener (with/without)
Interim rinses
Extended drying 14 - 45 minutes
Dishwasher width setting
Table 6-7: G 848 Programming Flow Chart
6.8.2.1 Programming Mode
1. To access the programming mode, close the door and turn the program
selector switch to Stop. Turn the dishwasher off.
2. Press and hold the Start button while turning the dishwasher on. Release the
Start button within 2 seconds. A blinking Salt light indicates successful
accessing of the programming mode.
3. Turn the program selector switch to the position indicated in Table 6-8 to modify
the corresponding function.
4. Use the Start button to toggle the functions on or off.
5. After selecting options, turn the program selector switch to Stop and turn the
dishwasher off.
Selector switch
position (o’clock)
Function Options Status of Start light
1 to 8 Water hardness See Section 6.8.2.1.1 Light 1 to 8 on
1
9 Extended drying
On
2
Off
Off
On
11 Water intake time
70 seconds
2
100 seconds
Off = 70 sec
On = 100 sec
Table 6-8: G 848 Programming Functions
1
If no lights light up, the dishwasher is programmed for “without water softener”. To change to
“with water softener”, follow the steps in Service Mode 2 (Section 6.8.2.3).
2
Factory setting