Technical information

Technical Information
133
G 600/G 800
Program button 6
Program button
light
Fault code and description
Pressed 1 F05
Water drainage failure, heater level
switch
Pressed 2 F06
Too few pulses at flow meter / start of
water intake
Pressed 3 F07
Too few pulses at flow meter / end of
water intake
Pressed 4 F08 Water intake failure, heater level switch
Pressed 5 F09
Heater level switch not switching on at
the end of thermal stops
Table 6-79: G 818, G 658, G 858 Fault Codes
1
All wash programs can be run, but the heating element will not function during the cycle.
6.8.14.3.2 Deleting Stored Fault Codes
1. Access Programming Mode.
2. Press program button 6 twice.
3. A flashing program button 6 indicates successful fault code deletion.
4. Turn off the dishwasher.
6.8.14.3.3 Program Index
1. Access Service Mode 2.
2. Press the flashing program button 5.
3. Press the flashing program button 2.
4. The lit program button (1 to 5) will determine the corresponding program index, as shown
in the program index chart (Table 6-80).
5. Switch the dishwasher off.
Program button 1 - 5 Program index Electronic version
1 P0 EPLG 546
2 P1 For future modifications
3 P2 For future modifications
4 P3 For future modifications
5 P4 For future modifications
Table 6-80: G 818, G 658, G 858 Program Indices
6.8.15 G 879
Programming Flow Chart
Enter Programming Mode
To access:
Water hardness settings
Heated drying
Temperature reduction (EPLG 501A only)
Extended water intake (EPLZ 530 only)
Buzzer (EPLZ 530 only)
Enter Service Mode 1
To access:
Manual step mode
Component test program