Technical information

Technical Information
126
G 600/G 800
Program button Function Options Button light status
1 Heated drying
On
2
Off
Off On
2 Water hardness setting
See Section
6.8.13.1.1
Flashing = 1 to 70 gpg
3 Water intake time
70 seconds
2
Off = 70 seconds
100 seconds On = 100 seconds
4 Buzzer
On Off
Off On
Table 6-68: G 803, G 643, G 843, G 663, G 863 Programming Mode
1
If no lights light up, the dishwasher is programmed to “without water softener”. To change to “with
water softener” follow the steps in Service Mode 2 (6.8.13.3).
2
Factory setting
6.8.13.1.1 Setting the Water Hardness Level
1. Measure the water hardness in grains per gallon (gpg).
2. Access Programming Mode
3. Press program button 2 (should be flashing). If program button 2 is not flashing, Service
Mode 2 must be accessed (Section 6.8.13.3) and the dishwasher programmed to “with
water softener”.
4. Models with display: Press program button 2 repeatedly until the desired water
hardness is shown in the display. Display will read “A”, followed by one or two digits (e.g.,
for a water hardness of 22, the display will read “A”, “2”, “2”).
Models without display: Using Table 6-69 below, press the program button that
corresponds to the water hardness (e.g., for a water hardness of 10 gpg, press program
button 4). Once the button is pressed for the selected water hardness setting, program
button 2 will flash.
5. To save: Press program button 6 twice. A flashing program button 6 indicates successful
saving of data.
Water hardness (gpg) Program button 6 Program button lit
1-5 Not pressed 1
6-7 Not pressed 2
8 Not pressed 3
9-11 Not pressed 4
12-14 Not pressed 5
15-16 Pressed 1
17-21 Pressed 2
22-24 Pressed 3
24-31 Pressed 4
32-70 Pressed 5
Table 6-69: G 803, G 643, G 843, G 663, G 863 Water Hardness Settings
6.8.13.1.2 Checking the Water Hardness Level
1. Access Programming Mode.
2. Models with display: Press program button 2. The display will indicate the current water
hardness level setting (“A”, “#”, “#”).
Models without display: Press program button 2. A program button (1 to 5) will light,
indicating the current water hardness setting. Match the lit button to Table 6-69. If a
button does not light, press program button 6. The program button that lights along with
program button 6 will indicate the water hardness level setting.
3. Turn the dishwasher off.