Technical information
Technical Information
124
G 600/G 800
1. To access Service Mode 2, close the door and turn the dishwasher on. All
program lights should light. If not, press the Start/Stop button to cancel the
program. Turn the dishwasher off.
2. Press and hold the Top solo and Start/Stop buttons while turning the
dishwasher on. Successful accessing of Service Mode 2 is indicated by a dot (.)
in the display and flashing Drain and Salt lights.
3. Press the appropriate program button indicated in Table 6-64 to modify the
corresponding function.
4. Use the Top solo button to toggle through the function settings.
5. To save: Press the Start/Stop button twice and turn the dishwasher off.
Program button Function Options Display
Pots & Pans Fault codes - F00, F01, etc.
Sani Wash Operating hours - e.g., 001
Normal Plus Operating hours - e.g., 127
Normal EGS
On 40
Off 41
China/Crystal Increase temperature
150°F 50
160°F 51
Light Wash Water softener
With
1
60
Without 61
Economy Increase water level
Standard 70
Increased 71
Short Interim rinses
1 80
2 81
Energy saver Extended drying
1
14 minutes 90
45 minutes 91
Table 6-64: G 898 Service Mode 2 Functions
1
Factory setting
6.8.12.3.1 Accessing Fault Codes
1. Access Service Mode 2.
2. Press the Pots & Pans program button.
3. The fault code will be shown in the display, e.g., F01, F02, etc.
4. Use the fault chart (Table 6-65) to determine which fault has been stored in the
dishwasher.
5. Turn the dishwasher off.
Fault code Fault
F00 No error
F01 NTC or NTC connections open-circuited
F02 NTC or NTC connections short-circuited
F03 Electronic failure, selector switch position not found
F04
Heating failure - heating circuit opened or defective
electrical component in heating circuit
F05 Water drainage failure, heater level switch
F06 Too few pulses at flow meter / start of water intake
F07 Too few pulses at flow meter / end of water intake
F08 Water intake failure, heater level switch
F09 Heater level switch not switching on at the end of thermal stops
Table 6-65: G 898 Fault Code Chart