Technical information

Technical Information
118
G 600/G 800
2. Press and hold the Delay Start and Start/Stop button while turning the dishwasher on.
Flashing Intake/Drain and Salt lights and a lit Rinse light indicate successful accessing
of Service Mode 2.
3. Press the Top solo button twice. Flashing Intake/Drain and Salt lights and a lit End light
indicate successful accessing of Stage 3 of Service Mode 2.
4. Use the arrow buttons to scroll to the appropriate program function.
5. Use the Top solo button to change the status of the function.
6. To save, press the Start/Stop button twice.
Program Function Options
Status of program
light
Pots & Pans Increase temperature
66 Flashing
72 Lit
Sani Wash Water softener
On Flashing
Off Lit
Normal Plus Interim rinses
1 rinse Flashing
2 rinses Lit
Normal Increase water level
Norm Flashing
Increase Lit
China & Crystal Extended drying
Off Flashing
On
1
Lit
Economy EGS
With Off
Without On
Table 6-56: G 694, G 894 Service Mode 2 Functions
1
Can only be set if “+14 min” is selected in programming mode. See Section 6.8.10.1.2.
6.8.11 G 896
Programming Flow Chart
Enter Programming Mode
To access:
Water hardness settings
Extended drying fan time (+14 minutes)
Enter Service Mode 1
To access:
Manual step mode
Component test program
Enter Service Mode 2
To access:
Error messages
Program index
Increased water temperature selection
Water softener (with/without)
Interim rinses
Extended water intake
Extended drying fan time (+ 45 minutes)
EGS
Table 6-57: G 896 Programming Flow Chart