Technical information

Technical Information
107
G 600/G 800
Fault code Fault
F00 No error
F01 NTC or NTC connections open-circuited
F02 NTC or NTC connections short-circuited
F03 Electronic failure, selector switch position not found
F04
Heating failure - heating circuit opened or defective
electrical component in heating circuit
1
F05 Water drainage failure, heater level switch
F06 Too few pulses at flow meter / start of water intake
F07 Too few pulses at flow meter / end of water intake
F08 Water intake failure, heater level switch
F09 Heater level switch not switching on at the end of thermal stops
3 dashes (---) in display Indicates a F1, F2, F4, or F9 fault is stored in the memory
Table 6-38: G 890 Fault Code Chart
1
All wash programs can be run, but the heating element will not function during the cycle.
6.8.7.3.2 Deleting Stored Fault Codes
Access Programming Mode and press Start/Stop twice.
6.8.7.3.3 Operating Hours
1. Access Service Mode 2.
2. Press the appropriate program button indicated in Table 6-39 to display operating hours.
Program button Display
Sani Wash First 3 digits of total operating hours
Normal Plus Last 3 digits of total operating hours
Table 6-39: G 890 Operating Hours
Example:
Sani Wash: 007
Normal Plus: 127
Total operating hours: 7.127 hours
6.8.8 G 891
Programming Flow Chart
Enter Programming Mode
To access:
Program index
Water hardness settings
Extended drying fan time (+14 min)
Buzzer
Enter Service Mode 1
To access:
Manual step mode
Component test program