Technical information

Technical Information
104
G 600/G 800
Display Fault registered
F00 No fault registered
F01 NTC sensor or connections open-circuited
F02 NTC sensor or connections short-circuited
F03 Electronic fault
F04 Heating fault
Table 6-34: G 885 Fault Codes
Touchtronic Models
6.8.7 G 890
Programming Flow Chart
Enter Programming Mode
To access:
Program index
Water hardness settings
Buzzer
Enter Service Mode 1
To access:
Manual step mode
Component test program
Enter Service Mode 2
To access:
Error messages
Operating hours
Flow meter pulses
Increased water temperature selection
Water softener (with/without)
Extended water intake
Table 6-35: G 890 Programming Flow Chart
6.8.7.1 Programming Mode
1. To access the programming mode, close the door and turn the dishwasher on.
All program lights should light. If not, press the Start/Stop button to cancel the
program.
2. Press and hold the “+”and Start/Stop buttons while turning the dishwasher off,
then on. Successful accessing of the programming mode is indicated by a
blinking Salt light and the display showing P00, P01, etc., depending on the
electronic version.
3. Press the appropriate program button indicated in Table 6-36 to modify the
corresponding function.
4. Use the Top solo button to toggle the functions on or off.