NOVOT ONIC Operating instructions for condenser tumble dryer T 440 C It is essential to read these operating instructions before installing or using the machine to avoid the risk of accident, or damage to the machine. Q T.-Nr.
Contents Page Guide to the appliance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 For the user Warning and safety instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Notes on laundry care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Loading and unloading washing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Programme selection . . . .
Guide to the appliance 1 a.c.
Guide to the appliance Pushbuttons Programme selector switch Door opens the door Cottons On/Off for switching the appliance on and off. Low temperature low temperatures for delicate fabrics, e.g. acrylics. Buzzer sounds when the drum turns during the intermittent anti-crease action period.
Guide to the appliance Environmentally conscious drying Energy saving tips The sensitive system automatically adjusts drying to suit the water quality. The water conductivity is measured, and registered by the control which then compensates to achieve a uniform residual moisture level. The Novotronic control offers 9 programmes with electronic moisture measuring and 2 timed programmes.
Warning and safety instructions The electrical safety of this machine can only be guaranteed when continuity is complete between the appliance and an effective earthing system which complies with local and national regulations. It is most important that this basic safety requirement is regularly tested by a qualified electrician. The manufacturer can not be held responsible for the consequences of an inadequate earthing system. The machine is built in accordance with current safety requirements.
Notes on laundry care Before drying, check the drying symbol on the textile care label. Significance of symbols: q = Dry at normal temperature r = Dry at low temperature s = Do not tumble dry If no symbol is featured dry at your own risk applying the following principles: – Cottons and minimum iron items should be dried at a normal temperature at the appropriate programme setting. – For delicate fabrics, e.g. acrylic fibres, the low temperature setting should be selected.
Loading the machine Load the laundry very loosely into the drum. Duvet covers and pillowcases should be fastened before drying in order to prevent small items from being rolled inside them. Unloading the machine At the end of the programme remove the washing from the machine. If this is not done, the machine automatically proceeds into an intermittent anticrease action for 60 minutes. This entails the drum being rotated at short intervals in order to reduce the possibility of the formation of creases.
Programme selection Selecting a programme This tumble dryer is fitted with an electronic sensor system. The required degree of dryness is measured and monitored electronically so that the heating element is switched off as soon as it is reached. The drying cycle automatically finishes with a cooling down period. This may be followed by the anti-crease action cycle.
Programmes - Cottons Extra dry Hand iron rr Multi-layer fabrics which would not be thoroughly dried using the “Normal +” programme. Cotton or linen fabrics, e.g. table linen, bedding, starched laundry, etc. max. 5 kg Note: Jerseywear tends to shrink depending on the quality and type of manufacturing involved. The “Extra dry” programme should therefore not be selected for these fabrics. Normal+ Mixed load of cotton fabrics, e.g. towelling and jerseywear, i.e. single-layer and multi-layer fabrics. max.
Programmes - Minimum iron and timed drying Normal + 15 minutes cool air Minimum iron items made of synthetics or blended fabrics, e.g. pullovers, dresses, trousers, etc., which are not dried adequately in the “Normal” programme. Items which are only to be aired. max. 2,5 kg max. 5 kg 20 minutes warm air Individual items, e.g. bathing towels, bathing trunks. Normal Minimum iron shirts, table cloths, etc., made of blended woven or knitted fabrics, e.g. cotton/synthetics. max.
Programmes - Consumption data Capacity Final spin speed Electricity in a domestic consumption washing machine (kg) (rpm) (kWh) Drying time incl. cooling down time (mins) Extra dry 5 1200 1400 1550 3.44 3.28 3.17 87 83 81 Normal + 5 1200 1400 1550 3.17 3.02 2.91 81 77 75 Normal 5 1200 1400 1550 2.88 2.74 2.64 74 71 69 Hand iron rr 5 1200 1400 1550 2.10 1.96 1.86 56 53 51 Machine iron 5 1200 1400 1550 1.65 1.51 1.41 47 43 41 Normal + 2.5 1000 1.68 50 Normal 2.5 1000 1.
Emptying the condensed water container During the programme, water is condensed and collected in a container on the left behind the fascia panel. The container holds approx. 4 litres and should be emptied after each drying programme. When the container is empty, release the cap. The spout closes automatically. Push in the container until it clicks into place.
Cleaning and care The fluff which occurs during drying is collected in the fluff filter in the door. Clean the filter after every programme to save time and energy. Remove fluff from the filters in the door opening. These filters can be taken out and rinsed if necessary. Dry the filters before putting them back in place. Grip the filter by the recessed handle and pull upwards to clean. Remove any remaining fluff from the hollow part of the door through the wide slit at the bottom.
Cleaning and care Heat exchanger The heat exchanger should be cleaned once or twice a year. Before cleaning, disconnect the machine from the mains supply.
Cleaning and care Pull out the heat exchanger – and along the two long sides Stand the heat exchanger lengthwise on a towel until it is quite dry Replace the heat exchanger in the reverse order. Attempt to pull forward the heat exchanger and the flap to check that both are firmly positioned, as otherwise water may leak from the machine.
Problem solving guide Electrical appliances should only be repaired by qualified personnel. Incorrectly repaired machines may pose a considerable risk to the user. There are, however, minor faults which can be corrected without contacting the Service Department. The tumble dryer fails to start when switched on. Check whether the “On” indicator lamp lights up. If so, failure to start may be due to an incorrect selection procedure sequence when switching on the machine.
Problem solving guide To open the door in the event of power failure The “Anti-crease” indicator lamp in the sequence indicator display starts flashing. Release the “On/Off” button and then press it in again. Press the“Start” button. If the indicator lamp starts flashing again, this indicates a fault in the machine. Please then contact your Miele Dealer or the Miele Service Dept. The drum door opens during the drying cycle. Using the spatula provided lever the door open.
Problem solving guide The interior drum lighting fails to function. The bulb may be defective. Replace it as follows: Switch off the machine or disconnect from the mains supply. Open the door. After-sales service In the event of any faults which cannot be remedied, or if the appliance is under guarantee, please contact: – your Miele Dealer or – the nearest Miele Service Department (see back cover for the address). When contacting the Service Department, please quote the Model and Serial nos.
Installation Important The grille below the drum door should never be blocked, as this will prevent a sufficient intake of cold air. Installation It is possible to install this appliance under a continuous worktop / in a row of kitchen units using a special conversion kit*. The machine lid is replaced by a coverplate which must be fitted by a suitably competent person to ensure electrical safety. The machine must be perfectly level to ensure safe and proper operation.
Electrical connection For U.K. only: This tumble dryer is supplied ready for connection to an a.c. single phase 230 V, 50 Hz supply. The rated load is 3 kW. The machine is supplied with a 2 m long mains cable with moulded plug and the fuse rating is 13 A. The appliance should be connected up only by a qualified electrician, in accordance with national and local safety regulations. For other countries: This tumble dryer is supplied ready for connection to an a.c. single phase 220 V, 60 Hz supply.
External drainage of condensed water The condensed water can be drained off directly if the machine is installed near a sink, drain outlet, etc. Accessories supplied: Push the drain hose onto the drain outlet. Make sure that the hose is firmly secured by the clip and not kinked. - 2 m drain hose - Hose clamp - Rubber connection sleeve - Hose clip Installation: Max. drain hose length: 3.0 m Max. delivery head: 1.
External drainage of condensed water The machine is fitted with a non-return valve as standard to prevent water from flowing back into the machine (eg. if the machine is connected to a siphon). Connection to wash basin drain outlet Push the hose clip (1) and knurled nut connector (2) (from the sink drain outlet) over the drain hose. Put the adapter sleeve (3) supplied into the hose. Close the water inlet port above the condensed water container with the bottom part of the rubber plug.
Technical data Height. . . . . . . . . . . . . . . . . . . . . . . . . . 85.0 cm (adjustable +1/-0.5 cm) Width . . . . . . . . . . . . . . . . . . . . . . . . . . 59.5 cm Depth (incl. distance from wall) . . . . . . 60.0 cm Weight . . . . . . . . . . . . . . . . . . . . . . . . . 55 kg Drum volume . . . . . . . . . . . . . . . . . . . . 103 l Capacity . . . . . . . . . . . . . . . . . . . . . . . . 5 kg dry weight Voltage . . . . . . . . . . . . . . . . . . . . . . . . . Fuse rating . . . . . .
Alteration rights reserved / 000 GB - 5095
