Technical data

3 Fault Repair

3.1 LED Anti-Crease/End lights up solid

Symptom

This fault occurs in the normal operating mode, only in residual moisture

programs.

Program stop, cooling air phase, intermittent buzzer tone.

Opening and then closing the door deletes this fault message.

Cause

The drum is empty, or loaded with a few laundry items only. The laundry is too

dr y.

The residual moisture sensor (B3/1) voltage circuit is high-ohmic, the residual

moisture sensor has no-load detection, this is not a technical fault.

No-load detection, refer to 030 2.1 No-load detection.

Remedy

A Correct the load, or switch to a timed program.

Cause

Defective residual moisture sensor (B3/1).

Check the residual moisture sensor (B3/1)

A Check the residual moisture sensor (B3/1) for low-ohmic (continuity) status,

refer to Service mode summary, 090 4.3.

Descriptive Technical Documentation

090-6 DTD no. 12-9800