Operating instructions Vacuum cleaners S 2111 / S 2121 / S 2131 To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before using it for the first time. These operating instructions apply to standard models S 2111 / S 2121 / S 2131 as well as to other S 2000 series vacuum cleaners which are distinguished by names rather than numbers. en - AU, NZ M.-Nr.
Contents Caring for the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Description of the vacuum cleaner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Warning and safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Preparing for use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Using the accessories supplied . . . . . . . . . . . . .
Caring for the environment Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of babies and young children. Danger of suffocation.
Description of the vacuum cleaner 4
Description of the vacuum cleaner a Handle XXL * b Handle * c Air inlet valve d Release button e Connection piece for storage * f Telescopic tube * g Connection socket h EasyLock tube * i Slide controls for the telescopic tube * j Dust compartment release button k Suction power selector * l Floorhead * m Carrying handle n Dustbag o Dust compartment filter (for motor protection) p Air Clean filter (AC) q On/Off foot control s r ParkSystem s Mains cable t Foot switch for automatic cable rewind u Dustbag chang
Warning and safety instructions Safety with children This appliance conforms to current safety requirements. Improper use of the appliance can, however, present a risk of both personal injury and material damage. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before installation and before using it for the first time. They contain important notes on its safety, operation and maintenance.
Warning and safety instructions ~ There is a metal inlay underneath the handle which is designed to avoid the unpleasant effects of electrostatic discharges. Please make sure that you keep your hand in constant contact with this metal strip during vacuuming. ~ Do not pull or carry the vacuum cleaner by the cable and be careful not to damage the cable when withdrawing the plug from the socket. Keep the cable away from sharp edges and do not let it be squashed, for example, under a door.
Warning and safety instructions ~ Do not vacuum up any inflammable or combustible liquids or gases and do not vacuum in areas where such substances are stored. The cleaner might explode. ~ Do not vacuum up items which are heavy, hard or have sharp edges. They could cause a blockage and damage the appliance. ~ Floor attachments, accessories and tubes must not be used at head level to avoid the risk of injury, e.g. to eyes and ears. Danger of injury.
Preparing for use Attaching the suction hose a ^ Insert the hose connector into the suction socket until it clicks into position. To remove the suction hose b ^ Press the release buttons at the side of the hose connector, and lift the hose from the socket. Depending on the model your vacuum cleaner has one of the following tubes (see "Description of the vacuum cleaner").
Preparing for use Adjusting the telescopic tube One part of this telescopic tube is packed inside the other and can be adjusted to suit your height for comfortable vacuum cleaning. ^ Press the telescopic tube release button to release the tubes and adjust to the required height. Fitting the standard floorhead a ^ Push the suction tube into the floorhead and turn it clockwise or anticlockwise until it clicks into position.
Using the accessories supplied The following accessories are supplied: a Dusting brush b Upholstery nozzle c Crevice nozzle d VarioClip for the above accessories Symbols on the holder show where to attach the different accessories. VarioClip ^ Attach the VarioClip either on-hand at waist level or on-board at the connector. Make sure it clicks into position. e Your Miele vacuum cleaner can be fitted with optional Active Air Clean / Active HEPA filter.
Use Pull out the mains cable a ^ Pull out the mains cable to the required length (max. cable length approx. 5.5 m). ,If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. Otherwise there is a danger of overheating. Rewinding the cable b ^ Switch off at the wall socket and remove the plug. ^ Press the rewind foot switch. The cable will rewind automatically. Switching on and off ^ Step on the On/Off foot control s. ,When vacuuming especially fine dust, e.g.
Use Adjusting the suction power The suction power can be regulated to suit the type of flooring. Reducing the suction power reduces the amount of effort required to manoeuvre the floorhead. Some models also have symbols on the controls. The symbols indicate the type of use the settings are suitable for.
Parking and storing ParkSystem A parking system has been designed for conveniently parking the vacuum cleaner during pauses. ^ Slot the floorhead into the parking attachment at the back of the vacuum cleaner. If the vacuum cleaner is on a sloping surface, e.g. on a ramp, - retract the telescopic tube fully - do not use the ParkSystem if your vacuum cleaner is fitted with an EasyLock suction tube. Storing ^ Stand the vacuum cleaner upright when it is not being used and during storage.
Maintenance and care ,Always disconnect the vacuum cleaner from the electrical supply for maintenance work and for cleaning. Switch off at the wall socket and remove the plug. The Miele filter system consists of three filters which must be replaced from time to time to ensure that your vacuum cleaner performs efficiently. Purchasing new dustbags and filters Genuine Miele dustbags can be ordered via the internet at www.miele-shop.
Maintenance and care When to change the dustbag Change the dustbag when the colour marker in the dustbag change indicator fills the display red, or sooner if it is no longer effective. Miele dustbags are disposable, and designed for single use only. Do not attempt to re-use them as suction would be reduced. Checking the dustbag change indicator ^ Attach the standard floorhead to the suction tube. How the dustbag change indicator works ^ Switch the vacuum cleaner on and select the highest power setting.
Maintenance and care Replacing the dustbag ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. The dustbag has a closing flap which closes automatically when the dust compartment lid is raised to prevent any dust escaping. Replacing the dustbag a ^ Pull the dustbag out by the grip next to the self-closing flap on the collar. Refitting the dustbag b ^ Fit the new dustbag into the holder as far as it will go. Leave it folded up when you take it out of the box.
Maintenance and care When to change the dust compartment filter (for motor protection) Replace this filter every time you start a new packet of dustbags. An exhaust filter is supplied with every packet of Miele dustbags. How to change the dust compartment filter ^ Open the dust compartment lid. ^ Unclip the filter frame and replace the dust compartment filter. ^ Close the filter frame. ^ Close the filter frame and the dust compartment lid.
Maintenance and care Replacing one type of exhaust filter with another Your Miele vacuum cleaner can be fitted with optional Active Air Clean / Active HEPA filter. This filter can be used instead of the Air Clean filter, which is supplied as standard. Remove the exhaust Air Clean filter and the filter grille and replace with the new Active Air Clean or Active HEPA filter. Remember: do not use two types of exhaust filters together.
Maintenance and care When to change the thread lifters The thread lifters on the suction inlet to the floorhead can be replaced. Check them from time to time and replace them if the pile has worn down. To replace the thread lifters Floor head SBD 350-3 ^ Use a suitable tool to remove them from the slots a. ^ Fit new thread lifters b. Floor head SBD 450-3 (S2131 only) ^ Use a suitable tool to remove them from the slots. ^ Fit new thread lifters.
Problem solving guide The vacuum cleaner switches off automatically. A temperature limiter switch switches the vacuum cleaner off automatically if it gets too hot. This can occur if, for instance, large articles block the suction tube or when the filter bag is full or contains particles of fine dust. A heavily soiled exhaust or dust compartment filter can also be the cause for overheating. Switch off the vacuum cleaner using the On-Off switch s. Disconnect from the electricity supply.
After sales service / Warranty In the event of a fault that you cannot easily remedy, please contact – your Miele Vacuum Cleaner Specialist or – Miele (see back cover for address). Warranty The appliance is guaranteed for a period of 2 years. For information on the appliance warranty specific to your country please contact Miele. See back cover for contact details.
Electrical connection All work should be carried out by a suitably qualified and competent person in strict accordance with national and local safety regulations. The voltage connected load are given on the data plate located underneath the vacuum cleaner. Please ensure that these match the household mains supply. The fuse rating is quoted on the plug. The appliance is supplied with a cable and moulded plug ready for connection to a 230V/50Hz A.C. single phase supply.
Alteration rights reserved (S 2111 - S 2131) - 4810 M.-Nr.
