Operating instructions/Installation instructions

Supervisor level
93
Only cold water is used for the main
wash.
– Hot
Hot water is also added for the main
wash.
Hot water can only be added if the
wash temperature is above 86°F
(30°C).
Program cycle times will be longer if the
machine is not connected for hot water;
this may mean that the “Time left” dis-
play is incorrect.
First rinse
You can select the water type for the
first rinse in some programs.
– Cold (factory default)
Only cold water is used for the first
rinse.
– Hot
Hot water is also added for the first
rinse.
Final rinse
You can select the water type for the
last rinse in some programs.
– Cold (factory default)
Only cold water is used for the final
rinse.
– Hot
Hot water is also added for the final
rinse (only possible for programs with
a temperature of at least
140°F/60°C).
Low water pressure
If the water pressure is below 100kPa
(1bar), the program will be canceled
and the fault messageCheck water in-
take will appear.
If the on-site water pressure cannot be
increased, activating the settingLow wa-
ter pressure will prevent the program
from being canceled.
Factory default: No
Automatic dispensing
Automatic dispensing via an external
dispensing system can be activated
Factory default: Off
CapDosing
You can choose whether CapDosing is
displayed in the program settings.
Factory default: On