Programming instructions

10. Water inlet 1
Selection choice:
–
Automatic
If the water inlet valves are programmed to
"automatic" the required wash temperature is
achieved during the water intake by
controlling the cold and hot water inlet
valves.
The water inlet valves in the dispenser
drawer compartments are set as follows:
Inlet valve
Pre-wash compartment K1, W1
Main wash compartment K2, W2
Fabric conditioner compartment K3
Additional agent compartment K4
Direct water intake KD, WD
WRG inlet valve (Water recycling) K6
The following inlet valves are controlled
according to programme block:
Programme
sequence
Temperature area
Actual
temp. >
Rqrd.
Actual
temp. =
Rqrd.
Actual
temp. <
Rqrd.
Pre-wash 1 KD, K1 WD, W1,
KD, K1
WD, W1,
KD, K1
Pre-wash 2-10 KD, K1 WD, KD,
K1
WD, W1
Main wash 1 KD, K2 WD, W2,
KD, K2
WD, W2,
KD, K2
Main wash 1-10
(with pre-wash)
KD, K2 KD, WD,
W2, K2
WD, W2
Rinse 1 KD, K3 KD, WD,
K3
WD, K3
Rinse 1 KD,K4 KD,WD,K4 WD,K4
Rinse 2 KD, K3 KD, WD,
K3
WD, K3
Rinse 1 KD KD, WD WD
Rinse 2 KD,K4 KD,WD,K4 WD,K4
Rinse 3 KD, K3 KD, WD,
K3
WD, K3
Rinse 1 KD KD, WD WD
Rinse 2 KD,K4 KD,WD,K4 WD,K4
Rinse 3-9 KD KD, WD WD
Rinse 10 KD,K3 KD,WD,
K3
WD,K3
–
User defined
No
4 of 10 different inlet valves
The optimum hot water intake may not
always take place. However the actual
temperature will never be higher than the
required temperature. The controls will react
beforehand to bring in a different inlet valve.
Temperature area
Actual temp. >
Rqrd.
Actual temp. =
Rqrd.
Water valve W1 -> K1 W1, K1
Water valve W2 -> K2 W2, K2
Water valve WD -> KD WD, KD
11. Dispensing method
This stipulates how the agents are
dispensed into the machine.
Selection choice:
–No
No dispensing takes place
– Amount in ml (millilitre)
– Concentration in ml/l (millilitre per litre)
This does not appear when programming
the programme header for fill type "water
level", "auto load control"
–
Concentration ml/kg (millilitre per load of
laundry in kg)
Programming
M.-Nr. 06 533 430 23