Installation Plan Tumble dryer PT 8407 D (Steam Heated) en – US 23.15 M.-Nr.
U.S.A. Miele, Inc. National Headquarters 9 Independence Way Princeton, NJ 08540 Phone: 800-991-9380 609-419-4241 Fax: www.mieleusa.com Technical Service & Support Nationwide Phone: 800-991-9380 Fax: 800-220-1348 proservice@mieleusa.com It is essential to read the operating and installation instructions before installing, commissioning or using the machine. This avoids the risk of accidents or damage.
5 5/8 3/4 35 7/16 25 5/8 55 1/8 2 1/2 3/4 41 7/8 24 3/4 25 1/4 45 7/8 41 11/16 1 1/2 3/4 23 3/8 2 5/8 63 PT 8407 D - measurements in inches 3
< 45 7/8 41 11/16 63 PT 8407 D - measurements in inches 6 3/8 6 1/4 5 7/8 ~2 4
24 3/8 11 12 5 17 3/8 5 7/8 7 7/8 63 25 3/4 63 1 7/8 PT 8407 D - measurements in inches 5 12 17 3/8 25 3/4 2 5/8 5
Standard installation >2 3/4 3/4 55 1/8 55 1/8 Option: Installation on concrete base (BS) 2 1/8 > 2 1/8 15 1/2 42 > 47 1/4 42 41 11/16 63 63 15 1/2 31 1/8 > 2 1/8 21 31 1/8 2 1/8 > 35 1/2 35 7/16 ~2 3/8 PT 8407 D - measurements in inches ~2 ~2 >2 ~2 3/8 6
PT 8407 D - measurements in millimeters 7
< PT 8407 D - measurements in millimeters 8
PT 8407 D - measurements in millimeters 9
Standard installation PT 8407 D - measurements in millimeters Option: Installation on concrete base (BS) 10
Technical datasheet Tumble dryer: Heating: PT 8407 Steam (D) Legend: en - US Abbreviations in bold type: Connection required Abbreviations in circle with dashes: Connection optional or required depending on model version Optional extras: BS Concrete base Quality and density of concrete must comply with load.
Equipotential bonding Connection with male thread 3/8“ x 1 3/8“ 10 mm × 35 mm Connection with washers and nut 3/8” M 10 87 - 145 psi 329 - 363 °F 108 lbs/h ½" internal thread 600 - 1.000 kPa 165 - 184 °C 49 kg/h 19 11/16“ 500 mm Accessories to be ordered separately If necessary, equipotential bonding with good galvanic contact must be provided in accordance with all appropriate national and local regulations.
Fittings (supplied) Without base: 2 × clamps 2 × screws DIN 571 (Ø × length) 2 × rawl plugs (Ø × length) Machine must be bolted to the floor! Fixing materials for floor screed have to be provided on site. On concrete platform: 2 × clamps 2 × screws DIN 571 (Ø × length) 2 × rawl plugs (Ø × length) Machine must be bolted to the floor! Fixing materials for floor screed have to be provided on site.