Installation Plan Tumble dryer PT 8407 EL (Electrically Heated) en - US 35.14 M.-Nr.
U.S.A. Miele, Inc. National Headquarters 9 Independence Way Princeton, NJ 08540 Phone: 800-991-9380 Fax: 609-419-4241 www.mieleusa.com Technical Service & Support Nationwide Phone: 800-991-9380 Fax: 800-220-1348 proservice@mieleusa.com It is essential to read the operating and installation instructions before installing, commissioning or using the machine. This avoids the risk of accidents or damage.
5 5/8 3/4 35 3/8 25 5/8 55 1/8 20 1/2 3/4 25 1/4 55 1/8 24 3/4 41 7/8 45 7/8 41 3/4 23 3/8 1 1/2 3/4 2 5/8 63 PT 8407 EL - measurements in inches 3
35 5/8 35 3/8 < 45 7/8 41 3/4 63 PT 8407 EL - measurements in inches 6 3/8 6 1/4 5 7/8 2 4
11 52 7/8 63 24 3/8 7 7/8 12 5 63 12 5 5 7/8 PT 8407 EL - measurements in inches 5
55 1/8 2 3/4 3/4 55 1/8 2 1/8 31 1/8 15 1/2 42 47 1/4 42 41 3/4 63 63 15 1/2 2 1/8 21 2 1/8 21 31 1/8 2 1/8 35 3/8 35 3/8 2 3/8 PT 8407 EL - measurements in inches 2 2 2 2 3/8 6
PT 8407 EL - measurements in millimeters 7
< PT 8407 EL - measurements in millimeters 8
PT 8407 EL - measurements in millimeters 9
PT 8407 EL - measurements in millimeters 10
Technical datasheet PT 8407 Electric (EL) Tumble dryer: Heating: Legend: en - US Abbreviations in bold type: Connection required Abbreviations in circle with dashes: Connection optional or required depending on model version Optional extras: BS Concrete base Quality and density of concrete must comply with load. Concrete base must be firmly secured to floor! 4“ 2“ 35 3/8“ 47 1/4“ 100 mm 50 mm 900 mm 1200 mm 1. Standard voltage Frequency Rated load Fuse rating Connection cable, min.
Equipotential bonding Connection with male thread with washers and nut. 3/8“ x 1 3/8“ 10 mm × 35 mm Max. nominal air flow in vented mode Max. permissible pressure loss 28252 cu ft/h 0.04 psi 800 m³/h 300 Pa Connection on machine side (ext. diameter) Connection pipe provided on site (int. diameter) Max. temperature 5 7/8” 5 7/8” 176 °F 150 mm 150 mm 80 °C 82.
