Operating instructions/Installation instructions

Operation
50
At the end of the program
When a program ends normally, the LED for the Start/Stopbutton will
go out. The message Program finishedwill appear in the bottom line of
the display.
Normal Plus
Temperature
Program finished
55 °C
In addition, a buzzer will also sound for approx. 3 seconds (factory
default setting). To adjust the buzzer volume, see “Settings, Volume”.
To completely finish the program the door must be opened fully with
the dishwasher still switched on.
If the Switch-off function is enabled, the dishwasher switches itself
off after a short period of time.
Press the  button to switch the dishwasher on again.
Turning off the dishwasher
 Press the  button until the button's LED goes out.
Unloading the dishwasher
Dishes tend to break and chip more easily when they are hot. Allow
the dishes to cool until they are cool enough to handle before
unloading them.
The dishes will cool much faster if you open the door when the
program has ended.
First unload the lower basket, then the upper basket. This will prevent
water drops from the upper basket falling onto the dishes in the lower
basket.