Operation Manual

Installation
82
Connection to window contact,
if required
 The window contact is connec-
ted to the mains voltage!
Danger of electric shock!
Disconnect the hob from the mains
electricity supply before connecting
the switching mechanism.
The connection cable of the switch-
ing system must only be connected
by a suitably qualified and compet-
ent person.
The connection cable of the switch-
ing system must comply with type
H03VV-F 2x0.75mm
2
and must not
exceed 2.0m in length.
The switching system must be
equipped with a potential-free con-
tact suitable for 230V, 1A. The ex-
tractor is switched off when the
switch is open.
Only use DIPT-approved and tested
radio switching systems (e.g. window
contact switches, pressure switches)
and have them approved by author-
ised specialists (e.g. building regula-
tions inspector).
The switching system must be suit-
able for use with a BLDC motor.
You will need the appropriate ex-
ternal switching system documents
to safely connect and operate the
switch.
 Loosen the lug and pull the plug out.
 Loosen the strain relief screw and
unlock the casing on both sides.
 Open the casing.
 Remove the stopper.