Operating Instructions and Installation Instructions

Problem solving guide
46
Problem Cause and remedy
The food in the pan
does not heat up when
the A
uto heat-up func‐
tion is switched on.
A large amount of food is being heated up.
 S
tart cooking at the highest power level and then
turn down to a lower one manually later on.
The pan is not conducting heat properly.
 Use a differ
ent pot or pan which conducts heat
properly.
An operating noise can
be hear
d after the appli‐
ance has been switched
off.
The fan will continue running until the appliance has
coole
d down. It will then switch itself off automatical‐
ly.
One or more residual
heat indi
cators are
flashing.
There was an interruption to the power supply during
oper
ation or when residual heat was present.
You accessed the programming function while residu‐
a
l heat was still present.
The sensor switches
show i
ncreased sensi‐
tivity or fail to react.
The sensitivity level of the sensor switches has
changed.
 Mak
e sure that there is no direct light (from the
sun or from an artificial source) falling onto the
hob. The area surrounding the hob must not be
too dark.
 Mak
e sure that there is nothing covering the sen‐
sors or the hob.
Take any pans off the hob and wipe away any
food deposits.
 Int
errupt the power supply to the hob for approx. 1
minute.
 If
the problem persists after power has been re‐
stored, please contact Miele.