Operating and Installation Instructions Ceramic Cooktop KM 5676 To prevent accidents and appliance damage, read these instructions before installation or use. en - US, CA M.-Nr.
Contents IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Guide to the cooktop . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Before using for the first time. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Heat the cooktop . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 Resetting the touch controls . . . . . . . . . . . . . .
IMPORTANT SAFETY INSTRUCTIONS READ THE OPERATING INSTRUCTIONS CAREFULLY BEFORE USING THE COOKTOP WARNING This appliance is only intended for residential cooking. When using your appliance follow basic safety precautions including the following: Installation ~ Be certain your appliance is properly installed and grounded by a qualified technician in accordance with national and local safety regulations. ~ Do not connect the appliance to the main electrical supply using an extension cord.
IMPORTANT SAFETY INSTRUCTIONS Injury prevention ~ Children should not be left unattended in an area where the cooktop is in use. Never allow children to sit or stand on any part of the cooktop. Caution: Do not store items of interest to children in cabinets above the cooktop. Children climbing on the cooktop to reach these items could be injured. ~ Use the Safety Lock to prevent children from turning on the cooking zones or changing the settings. See "Safety lock" for more information.
IMPORTANT SAFETY INSTRUCTIONS ~ Never leave a cooktop unattended at high settings or when cooking with oil or fat. Overheated oil could ignite. Always heat oil slowly, monitoring it as it heats. ~ To prevent burns and breathing ~ Do not use water on grease fires. Smother or use a dry chemical or foam-type extinguisher on any fire or flame. ~ When wiping spills on a hot cooktop ~ When frying food make sure that the food is as dry as possible before placing it in oil.
IMPORTANT SAFETY INSTRUCTIONS Damage protection ~ Never place hot pots or pans over the touch controls, this may damage the electronics. ~ Do not drop anything on the ceramic surface of the cooktop. Even lightweight objects may cause damage. ~ Do not use pots or pans with pronounced edges or ridges on the ceramic cooktop. These could scratch the cooktop permanently. See "Selecting cookware" for more information. Grains of salt and sand can cause scratches.
IMPORTANT SAFETY INSTRUCTIONS Appliance safety Further safety notes ~ In the event of any damage to the appliance, it must be turned off immediately and disconnected from the main power supply. Call Miele’s Technical Service Department. Do not use the appliance until it has been repaired. Ensure power is not supplied to the appliance until repair work is completed. ~ Make certain that the power cords of ~ Do not cook on a broken cooktop.
Guide to the cooktop Burners ac Single burners df Variable burners b Extended burner e Controls Touch controls/Indicators g Burner controls j Child Safety Lock h Cooktop ON/OFF Indicator k Lock Indicator i Cooktop ON/OFF l Timer (see "Timer controls and display") 8
Guide to the cooktop Burner controls and display a Extended burner touch control b Power level touch controls c Extended burner indicator d Display: 0 1 to 12 # F A P0 etc. S0 etc.
Guide to the cooktop Timer controls and display a Auto turn off indicator, e.g. rear right burner b Time display c Touch control to turn the timer on/off, switch between functions and select a burner for auto turn off d Touch control for setting the time Burner data Burner KM 5676 diameter in Watts inches cm y 5 11/16 9 1/16 14.5 23 1100 2500 w 5 11/16 14.
Before using for the first time Clean the cooktop Heat the cooktop ^ Before using for the first time, clean the appliance with a damp cloth and dry with a soft cloth. Metal components of the cooktop have a protective coating which may give off a slight odor the first time the appliance is heated. The smell will dissipate after a short time and does not indicate a faulty connection or appliance defect.
Resetting the touch controls Automatic reset Manual reset To ensure the cooktop functions properly the touch controls will automatically reset: ^ Make sure no direct light (sun or artificial) beams on the cooktop. The surrounding area of the cooktop should not be completely shaded or brightly lit. – when the cooktop is connected to the power supply, – if there is an interruption to the power supply, and – during use in response to changing light conditions.
Use Turning on the cooktop Variable/Extended burner ^ Touch the s On/Off cooktop touch control. When turning on a variable or extended burner the extension of the burner will automatically turn on to create a larger cooking area for pots and pans. A horizontal bar - will appear in each of the burner displays and the On/Off indicator lights. If no setting is chosen within a few seconds the cooktop will turn itself off as a safety measure.
Use Settings Use for Power level* Melting butter, chocolate, etc. Dissolving gelatin Preparing yogurt 1-2 Thickening sauces containing egg yolk and/or butter Warming small quantities of food/liquid Warming sticky foods Cooking rice 1-3 Warming liquid or half-set foods Thickening sauces, e.g. hollandaise Cooking rice pudding 3-5 Defrosting frozen food Steaming vegetables, fish, etc. Cooking dumplings, pasta, soups, etc.
Use Cooking with Auto-heat To activate auto-heat When auto-heat has been activated, the burner turns on automatically at the highest setting and then changes to the continued power level which was selected. The "heat-up" time depends on which power level is chosen (see table). ^ Turn the burner on. If a high continued power level is selected, a shorter "heat up" time is required.
Use Cooking without Auto-heat ^ Turn the burner on. Touch the + sensor until the desired power level is displayed, e.g. 4. Additionally the power level is indicated by the number of segments in the lighting circle. For example: Power level 4 shows four segments.
Use Turning off a burner Residual heat indicator ^ Touch the s On/Off touch control for the desired burner. The bars in the residual heat indicator go out one after another while the burner cools. The last residual heat indicator will go out when the burner is cool enough to touch. The display will show - for a few seconds. If the burner is still hot, the residual heat indicator will show. Turning off the cooktop ^ Touch the s On/Off touch control for the cooktop. All burners are turned off.
Selecting cookware Following these tips will allow you to make the most of your ceramic cooktop. The cooking surface The ceramic cooktop is made of an extremely hard and durable material. The surface is scratch resistant, not scratch proof. Avoid using cookware with ridged bottoms. Ridged pots with dirty or chipped enamel bottoms may scratch the cooktop if they are pulled across the ceramic surface. Make sure the cooktop and pot bottoms are clean before cooking.
Selecting cookware Copper bottom and aluminum pans may leave a residue on the cooktop in the form of metallic lines. This is normal. These lines can be removed using a non-abrasive ceramic cooktop cleaner or a shielded scraper blade. Be sure to clean the cooktop after each use. Each time this residue is allowed to melt it becomes harder to remove and may mar the appearance of the cooktop. Let the cooktop cool before cleaning.
Timer The cooktop has a timer which can be used to time activities in the kitchen and/or automatically turn off the burners. Both functions can be used simultaneously. A time between 1 and 99 minutes can be set. The time can be decreased or increased with the - or + touch control. To set the display back to 00 press and + at the same time. If multiple times are programmed, the time which elapses first is displayed. If this time is allocated to a burner, the respective indicator will flash.
Timer Setting the timer to turn off a burner automatically To use this feature, a power setting must be selected for the desired burner. All burners can be programmed at the same time. ^ Turn the desired burner on, e.g. rear right, and select a power level. ^ Touch the m sensor until the indicator of the desired burner lights, e.g. rear right. If multiple burners are turned on, the indicators for the activated burners light clockwise from front left to front right.
Safety features Child Safety Lock Keep children away from the cooktop for their own safety. The cooktop has a Child Safety Lock to prevent children from turning on the burners or changing the settings. The Child Safety Lock can be activated while the cooktop is on or off. Activating the Child Safety Lock during cooktop use – The settings for the burners and timer cannot be altered. – The burners and cooktop can still be turned off but once turned off cannot be turned on again.
Safety features Stop and Go To deactivate Stop and Go: Your appliance has a Stop and Go feature which, when activated, reduces the power of all burners that have been switched on. ^ Press and hold the $ control until the indicator goes out. The burners will now run at the level previously set. If you then deactivate the feature, the burners will automatically return to the previous level. If the feature is not deactivated, the cooktop will turn off after 1 hour.
Safety features Safety cut-out feature Covered touch controls The cooktop is on too long The cooktop has a safety cut-out feature in case it is not turned off after use. If one of the burners is heated for an unusually long period of time (see table), and the power level settings are not adjusted, the cooktop will turn itself off automatically and the residual heat indicator will light. Power level* Maximum operating hours 1/1. 10 2/2. 5 3/3. 5 4/4. 4 5/5. 4 6 4 6. 3 7/7. 3 8/8. 3 9/9.
Safety features Overheating protection Each burner is equipped with a temperature limiter. This limiter turns off the heating elements in the burner before the ceramic surface becomes too hot. Once the ceramic surface has cooled to a safe temperature the heating elements will automatically turn back on. The overheating protection may be activated by: – turning on a burner without putting a pan on it. – heating an empty pan. – an uneven pan not sitting evenly on the burner.
Cooktop Settings The following default cooktop settings of the cooktop can be reprogrammed if needed: Auto-heat settings Default power Demo mode Power level range Residual heat indicator Safety lock Stop and go Timer function Timer start setting Timer tone Tone for touch controls Automatic turn on of outer portion variable/extended burner If you would like to reprogram the settings of your cooktop, please contact Miele for assistance.
Cleaning and Care Do not use a steam cleaner to clean this appliance. Steam could penetrate electrical components and cause a short circuit. Pressurized steam could cause permanent damage to the surface and to components. Do not use any sharp pointed objects which could damage the seal between the ceramic surface, the surrounding frame and the countertop. Never use abrasive cleaners, caustic (oven) cleaners, dishwasher detergent, scouring pads, steel wool or hard brushes. They will damage the surface.
Frequently asked questions ,Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. What if the cooktop or the burners cannot be turned on? Possible fault Solution The Safety Lock is activated. Deactivate the safety lock. See "Safety lock". The main fuse has blown. Check the main fuse.
Frequently asked questions What if one or more residual heat indicators flash? Possible fault Solution There was a power failure during use. The burners are turned off. Turn the cooktop on as usual. The residual heat indicators were lit while the programming mode, e.g. Safety Lock, was selected. The residual heat indicators will flash for about 45 minutes after leaving the programming mode. The cooktop can be used as usual.
Technical Service In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department using the information on the back of this manual. When contacting Technical Service quote the serial number and model of the cooktop. This information is visible on the silver data plate. MieleCare (USA only) MieleCare, our Extended Service Contract program; gives you the assurance of knowing that your appliance investment is covered by 5 years of worry free ownership.
Installation Instructions To prevent accidents and machine damage read these instructions before installation or use.
IMPORTANT SAFETY INSTRUCTIONS Note to the installer: Please leave this instruction book with the consumer for the local electrical inspector’s use. The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire. The cabinetry and venting hood should be installed first to prevent damage to the cooktop.
IMPORTANT SAFETY INSTRUCTIONS ~ To eliminate the risk of burns or fire by reaching over heated surfaces cabinet storage space above the cooktop should be avoided. If cabinet storage is necessary, the risk can be reduced by installing a venting hood to project horizontally a minimum of 5" beyond the bottom of the cabinets. Safety distances above the appliance ~ Because of the heat radiated it is not recommended to install the cooktop above a drawer.
Installation Cooktops flush with the countertop a Wall b Wall covering c Back splash d Countertop e Countertop cut-out f 2" (50 mm) minimum distance 34 Frame/Facet cooktops
Installation Installation dimensions a Spring clips b Installation height c Installation height power supply line d Front e Flexible stainless steel hose Length = 3’ 11" (1200mm) 35
Installation Cut out ^ Make the countertop cut-out following the dimensions given in the illustration. Remember to maintain a minimum distance of 2" (50 mm) between the rear wall and the right or left side. See also "IMPORTANT SAFETY INSTRUCTIONS". ^ Seal the cut surfaces with a suitable sealant to avoid swelling caused by moisture. The materials used must be heat resistant.
Installation Installing the spring clips Wood or solid surface countertops Granite countertops ^ Fix the supplied spring clips at the marked positions as shown above, by laying them on the upper edge of the cut-out and then securing them with the 1/8" x 1" (3.5 x 25 mm) screws supplied. ^ For granite countertops, the spring clips must be placed in position and secured with strong, double-sided adhesive tape. ^ In addition, coat the edges of the spring clips with silicone sealant.
Installation Installing the cooktop Wooden countertop ^ Feed the power cord down through the cut-out and connect the appliance to the power supply. ^ Position the cooktop on the spring clips, a. ^ Then with a hand on each side of the cooktop press down evenly on the edges until it clicks into position. When doing so make sure that the cooktop seal sits tightly on the countertop to ensure it is sealed correctly. The cooktop can now only be removed with a special tool.
Installation Sealing The cooktop must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the cooktop provides a sufficient seal for the countertop. If the cooktop is sealed into position, the countertop or appliance could be damaged if the cooktop needs to be removed for maintenance or service.
Electrical connection ,CAUTION: Before installation or servicing, disconnect the power supply by either removing the fuse, shutting off the main power supply or manually "tripping" the circuit breaker. Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by unqualified persons could be dangerous.
Help protect our environment Disposal of packing materials Disposal of an old appliance The cardboard box and packing materials are biodegradable and recyclable. Please recycle. Old appliances contain materials that can be recycled. Please contact your local recycling authority about the possibility of recycling these materials. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of children.
Alterations rights reserved / 4509 For the most updated manual see the Miele web site. M.-Nr.
