Operating and Installation Instructions

Switching on and off
21
Before first use
Packaging material
 Remove all packaging material from
the inside of the appliance.
Protective film
The stainless steel trim on the interior
shelves and door shelves in the
appliance has a layer of protective film
to prevent scratching in transit.
 Remove this protective film once the
appliance has been installed.
Cleaning the refrigerator
Please refer to the relevant
instructions in “Cleaning and care”.
 Clean the inside of the appliance and
the accessories.
 Clean the ice cube maker: after
selecting the “Rinse ice cube
maker” setting; the ice cube
maker and the water supply pipework
are rinsed automatically with water.
Operating the appliance
A light touch on the sensors is all that is
required to operate this appliance.
A tone will sound each time a sensor is
touched. You can deactivate this if you
wish (see “Selecting additional settings
- Audible signals”).
Switching on the appliance
Once the appliance is connected to the
electricity supply, the power supply
symbol  will soon appear on the
display.
 Touch the On/Off button.
The power connection symbol goes
out and the appliance starts to cool
down.
The sensor buttons for the available
zones will appear on the control panel:
The zone sensor button is highlighted in
yellow and the current temperature in
this zone appears on the display.